Inquiry Form

Close

Close

PRODUCTS

LL9UC

API Standard 682 seal

Mechanical seals for pumps
Pusher seals
  • Compact design
  • Low heat generation and power consumption due to narrow seal face width
  • Longer seal life
  • Pressure-balanced design prevents mating ring being forced out under reverse pressure
  • No damage to shaft sleeve as dynamic O-Ring is not in direct contact with the sleev

Feature

  • API 682 Category 2 and 3, Type A, Arrangement 1 seal
  • Single seal
  • Balanced
  • Cartridge unit
  • Rotating multiple springs
  • Solid seal faces

Product specification example

Standards and approvals

API 682 / ISO 21049

Materials

Seal ring: Blister resistant carbon, Silicon carbide SSiC (Q1), RBSiC (Q2)

Mating ring:Silicon carbide SSiC (Q1), RBSiC (Q2)

Secondary seals:FKM (V), FFKM (K), EPDM (E), NBR (P)

Springs: Hastelloy® C-276 (M5)

Metal parts: CrNiMo steel 316 (G)

Operating range

Pressure: p = vacuum … 42 bar (… 609 PSI)

Temperature: t = -40 °C … +176 °C (-40 °F … 349 °F)*

Sliding velocity: vg … 23 m/s (… 75 ft/s)

Viscosity: … 300 mPa·s

Solids content: … 0.5 wt.%

* Engineered up to 260 °C (500 °F) with FFKM (K) secondary

Recommended applications

Refining technology

Oil and gas industry

Petrochemical industry

Chemical industry

Power plant technology

Light volatile hydrocarbons

LPG plants API 610 / ISO 13709 pumps

Process pumps

Recommended piping plans

Process side: 01, 02, 11, 12, 13, 14, 21, 22, 23, 31, 32, 41

Atmospheric side: 51, 61, 62, 65A, 65B, 66A, 66B

Applicable ranges shown in the product introduction are limit values for each standard material.
Applicable ranges, performance data and figures can serve only as a guide for selection and therefore in actual use there will be some cases where general specifications cannot be applied due to unknown factors or constraints.
Please check the applicability before use.
The contents are subject to change without notice for improvement.

Contact

This website uses cookies to improve your online experience. By continuing to use this website, we will assume that you are agreeing to our use of cookies. For more information about cookies, please visit our " Use of cookies" at Privacy Policy.